• Clamping Steel collar
• Black oxide collar for cosmetic look
• Black Oxide Bolt
• Good non-marring holding with steel shafting
• Suitable for high temperature service
• Cost effective

Clamping collars fully engage the shaft without marring it. They provide greater holding power than a setscrew and are effective on both hard and soft shaft materials

Bore tolerance: +0.003”/-0.000”

Axial load capacity is an approximation only and based on the seating torque. Use at your own risk. Do not rely on to support a load when significant lose or injury could occur. Positive locking and interference with a groove, step or recess must be used to ensure axial load capacity.

For drawings and 3D models, click on a part number.

• Clamping 303 Stainless Steel collar
• Good corrosion resistance
• Stainless Set Bolt
• Good non-marring holding with steel shafting
• Suitable for high temperature service
• Cost effective

Clamping collars fully engage the shaft without marring it. They provide greater holding power than a setscrew and are effective on both hard and soft shaft materials

Bore tolerance: +0.003”/-0.000”

Axial load capacity is an approximation only and based on the seating torque. Use at your own risk. Do not rely on to support a load when significant lose or injury could occur. Positive locking and interference with a groove, step or recess must be used to ensure axial load capacity.

For drawings and 3D models, click on a part number.

• Clamping Aluminum collar
• Lightweight
• Good corrosion resistance
• Black Oxide Bolt
• Good non-marring holding with shafting
• Cost effective

Clamping collars fully engage the shaft without marring it. They provide greater holding power than a setscrew and are effective on both hard and soft shaft materials

Bore tolerance: +0.003”/-0.000”

Axial load capacity is an approximation only and based on the seating torque. Use at your own risk. Do not rely on to support a load when significant lose or injury could occur. Positive locking and interference with a groove, step or recess must be used to ensure axial load capacity.

For drawings and 3D models, click on a part number.